 Description: Polishing composition plaster inside, white color Caracteristics: Ipsos, minerals, polymers, plastifiers. - super-smooth surfaces - white - UV resistant - water vapor permeability. Domain of use: for finishing interior surfaces, without excessive moisture, to obtain very smooth surfaces that can be applied over virtually any painting. GLET & Print has a very high adhesion on cement-based plasters, cement-lime plasters and the plaster cast or precast concrete. Preparation of working surface: The skim surface support may be cement-based mortar, lime, plaster, concrete or brick, with surface irregularities of less than 5 mm. The surface is cleaned of dust, scrap paint, oil spots or other existing impurities. In summer, it is recommended pre-wetting of the skim support. Very porous surfaces will trigger. It is not directly applicable on painting! Application mode: Tools used: - toothed smoother steel or stainless steel - fine grinding paper - bucket - manual or mechanical mixer. The powder is introduced into water and start mixing. Both container and water used must be clean. Mixing is done vigorously, preferably mechanically (in an electric drilling machine is attached to a shaft with blades). Continue operation to obtain a creamy mixture, uniform, easily workable. Wait 10 minutes for completion of chemical reactions and stir again vigorously. Plaster thus obtained lies in thin layers (preferably toothed smoother of stainless material) to the media. When applying more coats, the next layer will be applied after the previous layer that is strengthening after a minimum of 6 hours. Applicability after mixing with water is for 1 hours. The surface is polished after 24 hours. At temperatures below 20°C for strengthening increases. Cleaning tools are made with water before strengthening pulp. Ambient temperature must be between 5°C and 30°C. Avoid direct sunlight beating. Recommendations: Surface is polished after 24 hours. At temperatures below 20°C for strengthening increases. Cleaning tools are made with water before strengthening pulp. Ambient temperature must be between 5°C and 30°C. Avoid direct sunlight beating. Storage: In dry place, in the closed, on wooden pallets. Packaging: bags of 5 kg, 20 kg bags and bags of 5 kg (free sample). Specific consumption: 0.5 - 1 kg / sq m |
| [back] |